Wasp

The Westland Wasp is a small 1960s British turbine powered, shipboard anti-submarine helicopter. Produced by Westland Helicopters, it came from the same P.531 programme as the British Army Westland Scout, and is based on the earlier piston-engined Saunders-Roe Skeeter. It fulfilled the requirement of the Royal Navy for a helicopter small enough to land on the deck of a frigate and carry a useful load of two homing torpedoes. Design and development The increasing speed and attack range of the submarine threat, and the increased range at which this threat could be detected led to a Royal Navy requirement for a "Manned Torpedo-Carrying Helicopter" (MATCH). Contemporary shipboard weapons did not have the necessary range, therefore MATCH was in essence a stand-off weapon with the helicopter carrying the torpedo or other weapon to the target and being instructed when and where to drop it. Unlike the larger Wessex, the Wasp carried no sonar of its own, and was limited strictly to working in partnership with its parent ship, other ships or other ASW units. The first prototype Saro P.531 flew on 20 July 1958, with the prototypes being subject to detailed testing by the Royal Navy, including the evaluation of several different undercarriage layouts, before settling on the definitive arrangement. An order for a pre-production batch of two "Sea Scouts" was placed in September 1961. The first flight of the two pre-production Wasp took place on 28 October 1962. Full production soon commenced, 98 in total being procured for the RN. The Wasp successfully exported to Brazil, the Netherlands, Indonesia, Malaysia, New Zealand and South Africa. 133 aircraft were built in total. Wasp was essentially a navalised Scout, indeed it was originally to be called the Sea Scout, and differed mainly in design details. It had a unique 4-wheeled castering undercarriage that allowed the aircraft to be manoeuvred on small, pitching flightdecks. The Wasp had the ability of "negative pitch" from the rotor-blades which enabled the aircraft to "adhere" to the deck until the lashings were attached. Additional fuel tankage was installed in the cabin floor and both the tail boom and main rotor blades were foldable to allow stowage in the small hangars fitted to the first generation helicopter-carrying escorts. It was fitted with a winch above the starboard rear door, and also had the capacity to carry underslung loads from the semi automatic cargo release unit mounted under the fuselage.