How to carve a turkey
By How To (/journals/how-to)
You free each large section at the joint before you slice across the grain. That keeps pieces intact and the juices on the platter instead of the board.
Before you start: a sharp thin carving knife, a carving fork, a large cutting board, a damp towel to grip the board, and a warm serving platter.
1: REST the turkey breast-up on the counter for twenty to thirty minutes after it leaves the oven.
Juices settle back into the meat so they do not flood the board at the first cut. Press the thickest part of the breast with one fingertip; it should spring back and feel warm, not scorching. If a thin stream runs out when you nudge a leg, wait five more minutes.
2: ANCHOR the board with a damp towel under it and the turkey breast-up, legs toward you.
A fixed board stops the bird from spinning under the knife. Give the board a light sideways shove; it must stay put. If it skids, refold the towel so more damp cloth grips the counter.
3: FREE one leg quarter by cutting the skin between breast and thigh, then bending the leg out until the hip joint opens, fork hand clear of the blade.
The joint yields with a soft pop when the knife finds the gap instead of bone. You will see the ball of the joint separate cleanly. If the edge hits hard bone, ease back about half an inch and aim for the soft crease.
4: LIFT the whole leg quarter away once the joint is open and lay it skin-side up on the board, then repeat on the other side.
One smooth lift keeps the skin from tearing. The quarter should come off in a single piece with no meat strings left on the backbone. If a strip of skin still tethers it, snip that last bit with the knife tip.
5: TAKE each wing off at the joint closest to the body with short cuts angled into the joint, not through bone.
The wing drops when the tip slips into the soft spot at the shoulder. The cut face should look like a clean knuckle, not splintered bone. If you meet resistance, wiggle the wing to show the joint line and cut there.
6: SLICE the breast in long downward strokes parallel to the breastbone, starting high at the center and working outward, fingers behind the fork.
Long strokes give wide even slices about a quarter inch thick. Each slice should hold together when you lift it with the fork. If the meat shreds or the knife drags, slow the stroke and keep the path parallel to the bone.
7: SEPARATE the thigh from the drumstick by cutting through the thin gap you feel when you bend them apart.
Bending opens a pale seam where the knife belongs. The two pieces part without cracking bone. If you strike dense bone, back up and probe for the softer line with the tip.
The most common mistake
Most people saw straight down through the breastbone and leave ragged chunks on the carcass. Work from the outside of each breast in toward the bone so each slice releases clean.
Pro tip
Warm the serving platter first so carved meat stays hot while you finish the rest of the bird.
Say it every time
Rest, anchor, free, lift, take, slice, separate